Site Updates


12/13/2009
Another club member located a small quantity of the 20-pin connectors used on the original Librascope card (cut down for the power pack), so I bought one.

05/25/2008

  • After a long break, I'm working on parts again. See the Collar page for progress shots.

    04/04/2005

  • I've been working on the ear posts, and put up a page about my attempts at molding and casting.
  • 04/20/2004

  • I added a picture of the controller for the finger lights and its schematic.
  • 04/05/2004

  • I put up some pictures of the round LED Lamps I made for the finger lights and the 3 lamps on top of the brain.
  • 03/29/2004

  • I added the first section for electronics, including some schematic diagrams .
  • 07/28/2003

  • I found some 1/2" acrylic, and made my waistplate, out of it .
  • 05/05/2003

  • I posted some shots of my powerpack, with an acrylic frame .
  • 01/10/2003

  • I modeled a microphone from miscellaneous parts.
  • 12/30/2002

  • After way too long of a break (after moving into the new house), I'm back to building again. I've started working on a home brew aluminum treadsection.
  • 07/15/2001

  • Added pictures of the brain assembled, and placed inside the bubble.
  • 06/25/2001

  • Added pictures of the painted brain cup, light rods and mostly assembled brain.
  • 06/04/2001

  • Added pictures of the light rods and the brass tubes used to build them.
  • 05/23/2001

  • Added another picture of the brain with the top plate added and some parts stacked up.
  • 05/13/2001

  • Added two more pictures of the brain and brain cup.
  • 01/13/2001

  • Added pictures of the aluminum crown.
  • 01/01/2001

  • Added two more pictures of the brain pan.
  • 12/27/2000

  • Added a picture of some of the brain cup parts, including the Hankscraft motor.
  • 12/24/2000

  • Added a couple of new pictures of the brain assembly.
  • 12/02/2000

  • Added a new page to track the progress of the brain.
  • 11/25/2000

  • Added vacuum formed neon backplate from Dewey Howard to the Parts page.
  • 11/23/2000

  • Added vacuum formed side panels from Dana Covert to the Parts page.
  • 11/18/2000

  • Added the Planet Plastics bubble and curved bottom plate to the Parts page.
  • Added Dewey's 2 piece neon neon to the Parts page.
  • Added Dewey's bubble lifter to the Parts page.
  • Added Mark Thompson's translucent resin cateyes to the Parts page.
  • Added the Tech 2000 neon transformer to the Parts page.
  • 11/13/2000

  • Added Dewey's fiberglass donut to the Parts page.
  • Added aluminum wristbands to the Parts page.